MacDon FlexDraper FD1 Series Operator's Manual page 457

Installing a new auger finger:
7. Remove the two bolts (B), tee nuts, and plug (A).
8. Coat bolts (A) with medium-strength threadlocker
®
(Loctite 243 or equivalent), and then insert the plastic
finger guide (B) from inside the auger and secure it with
bolts and tee nuts. Torque bolts to 8.5 Nm (75 lbf∙in).
NOTE:
When installing additional fingers, ensure you install an
equal number on each side of the auger.
9. From inside the auger, insert the new auger finger (B)
through the plastic guide (D).
10. Insert the finger (B) into finger holder (C) and secure
with hairpin (A).
NOTE:
Note the orientation of the hairpin (A). The round part
should face the direction of auger rotation; the formed
side (that is, the S-shaped side) must face the chain
drive side of the auger.
214683
MAINTENANCE AND SERVICING
Figure 5.75: Auger Finger Hole
Figure 5.76: Auger Finger Hole
Figure 5.77: Auger Finger
433
A
A
B
C
D
A
B
B
Revision A