List Of Revisions - MacDon FlexDraper FD1 Series Operator's Manual

List of Revisions

Summary of Change
Updated Declaration of Conformity for model
year 2019.
Added Ukrainian to the list of languages available.
Added FM100 safety decal locations.
Added safety decal MD #252996.
Updated illustrations of endshield hinge plate. Added
note to ensure hinge arm is installed in outboard hole
on the hinge bracket.
Updated illustrations to show transport lights.
Revised the high voltage limit adjustment instructions.
Added topic.
Added step and image showing the header
control switch.
Added settings for HEIGHT/TILT RESPONSE and
AUTO HEIGHT OVERRIDE.
Added settings specific to the two-sensor system.
Added steps to set center link to D, unlock float, and
lock wings.
Added steps for calibrating feeder house speed.
Removed unnecessary steps involving header float;
these steps are not applicable to reel height sensor
calibration.
Deleted note with link to height sensor adjustment; the
note isn't relevant to feeder house speed calibration.
Added step to lock wings before calibration.
214683
Refer To
Declaration of Conformity, page i
Introduction, page v
1.7 Safety Decal Locations, page 8
1.8 Understanding Safety Signs, page 13
•
Removing Endshields, page 36
•
Installing Endshields, page 37
Repositioning Fore-Aft Cylinders on Non-European-
Configured Headers with Multi-Crop Rapid Reel
Conversion Option, page 108
Adjusting Voltage Limits: One-Sensor System, page
131
Replacing Float Indicator Cable, page 135
Calibrating Auto Header Height Control (Case IH 5130/
6130/7130, 5140/6140/7140), page 146
Calibrating the Auto Header Height Control (Case
Combines with Version 28.00 or Higher Software),
page 160
•
Setting up the Header on the Combine Display
(Case IH 5130/6130/7130; 5140/6140/7140), page
142
•
Calibrating the Auto Header Height Control
(Case IH 7010/8010, 7120/8120/9120,
7230/8230/9230, 7240/8240/9240), page 156
•
Calibrating the Auto Header Height Control (Case
Combines with Version 28.00 or Higher Software),
page 160
Calibrating the Auto Header Height Control (Case
Combines with Version 28.00 or Higher Software),
page 160
Calibrating the Auto Header Height Control (John
Deere S and T Series), page 215
Calibrating Reel Height Sensor (John Deere S and T
Series), page 227
Calibrating Feeder House (John Deere S7 Series),
page 236
Calibrating the Auto Header Height Control (CLAAS
600 and 700 Series), page 251
vii
Revision A