Adjusting The Manual Header Raise/Lower Rate (John Deere 70 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Adjusting the Manual Header Raise/Lower Rate (John Deere 70 Series)

The weight of the header will dictate the rate at which the header can be raised or lowered during operation.

To manually adjust the header raise/lower rate, do the following steps:

Changes may have been made to the combine controls or display since this document was published. Refer to the

combine operator's manual for updates.

1. Press button (A) and the current raise/lower rate setting

will appear on the monitor (the lower the reading, the

slower the rate).

2. Use scroll knob (B) to adjust the rate. The adjustment

will be saved automatically.

If the screen remains idle for a short period of time, it

will automatically return to the previous screen.

Pressing the check mark button (C) will also return the

monitor to the previous screen.

The numbers depicted on the displays in these

illustrations are for reference purposes only; they are not

intended to represent the specific settings for your

Figure 3.337: John Deere Combine Control

Figure 3.338: John Deere Combine Display