MacDon FlexDraper FD1 Series Operator's Manual page 333

Wide configuration is an optional configuration for the
following combines:
•
Challenger (670B/680B, 540C/560C, 540E/560E)
•
CLAAS (590R/595R, 660/670, 760/770/780)
•
John Deere (T670)
•
Massey Ferguson (9895, 9540, 9560, 9545, 9565, 9380)
•
New Holland CX (8X0, 80X0, 8.X0)
NOTE:
This configuration may increase combine capacity on wide
feeder house combines in certain crop conditions.
NOTE:
In some conditions, feeding may be further improved by
removing all bolt-on flighting. Refer to
Modification to Wide Configuration, page
To convert to Wide configuration from Medium configuration, refer to
Configuration to Wide Configuration, page
To convert to Wide configuration from Narrow or Ultra Narrow configuration, refer to
Ultra Narrow or Narrow Configuration to Wide Configuration, page
Ultra Narrow configuration is an optional configuration
that may improve feeding performance on combines with
narrow feeder houses. It may also be helpful when
harvesting rice.
214683
HEADER ATTACHMENT/DETACHMENT
4.1.7 Optional
322.
318.
309
A
B
Figure 4.3: Wide Configuration (Rear View)
A - 257 mm (10-1/8 in.)
NOTE:
Dimensions are the same for both ends of the
auger. They should be within 15 mm (9/16 in.) of
the numbers given.
4.1.5 Converting from Medium
320.
Figure 4.4: Ultra Narrow Configuration
(Rear View)
A - 760 mm (29-15/16 in.)
NOTE:
Dimensions are the same for both ends of the
auger. They should be within 15 mm (9/16 in.) of
the numbers given.
B - 257 mm (10-1/8 in.)
4.1.6 Converting from
A
B
B - 602 mm (23-11/16 in.)
Revision A