Setting The Sensitivity Of The Auto Header Height Control (Claas 600 And 700 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Setting the Sensitivity of the Auto Header Height Control (CLAAS 600 and 700 Series)

The sensitivity adjustment controls the distance the cutterbar must travel up or down before the auto header height
control (AHHC) reacts and raises or lowers the feeder house. When the sensitivity is set to maximum, only small
changes in ground height are needed to cause the feeder house to raise or lower. When the sensitivity is set to
minimum, large changes in the ground height are needed to cause the feeder house to raise or lower.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
1. Use control knob (A) to highlight the HEADER/REEL
icon (B), and press control knob (A) to select it. The
HEADER/REEL dialog box opens.
2. Select HEADER icon.
3. Select the FRONT ATTACHMENT PARAMETER
SETTINGS icon (A). A list of settings appears.
4. Select SENSITIVITY CAC (B) from the list.
214683
OPERATION
B
Figure 3.443: CLAAS Combine Display,
Console, and Control Handle
Figure 3.444: CLAAS Combine Display,
Console, and Control Handle
255
A
A
B
Revision A