Setting Preset Cutting Height (New Holland Cr Series - 2015 And Later) - MacDon FlexDraper FD1 Series Operator's Manual

Setting Preset Cutting Height (New Holland CR Series – 2015 and Later)
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
page 261.
The console has two buttons used for auto height presets.
The toggle switch that was present on previous models is
now configured as shown at right. MacDon headers only
require the first two buttons (A) and (B). The third button (C)
is not configured.
CAUTION
Check to be sure all bystanders have cleared the area.
To set preset cutting height, follow these steps:
1. Engage separator and header.
2. Select preset button 1 (A). A yellow light on the button
will illuminate.
3. Raise or lower the header to desired cutting height.
214683
OPERATION
3.8.15 New Holland Combines (CR/CX Series—Pre-2015 Model Year),
281
A
B
C
Figure 3.499: New Holland Combine Controls
A
Figure 3.500: New Holland Combine Controls
Revision A