Calibrating Header (John Deere S7 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

12. When calibration is complete, select SAVE to confirm

calibration.

Calibrating Header (John Deere S7 Series)

Feeder house calibration must be done before header calibration. If feeder house has not yet been calibrated, refer

Calibrating Feeder House (John Deere S7 Series), page

For best performance of auto header height control (AHHC), perform these procedures with header at steepest

angle. When setup and calibration are complete, adjust center-link back to desired header angle.

Changes may have been made to combine controls or display since this document was published. Refer to

combine operator's manual for updates.

1. Ensure center-link is set to D.

2. Rest header on down stops and unlock float.

3. Place wings in locked position.

4. On the HARVESTING page, select the MENU icon (A)

in the bottom right corner of screen. The MENU opens.

Figure 3.408: John Deere S7 Display – Feeder

House Calibration

Figure 3.409: John Deere S7 Display –

Harvesting Page