MacDon FlexDraper FD1 Series Operator's Manual page 98

3. Adjust the center-link (A) so that indicator (B) is
between B and C on gauge (C).
4. Park combine on level ground and raise header until
cutterbar is 152–254 mm (6–10 in.) off the ground.
5. Shut down the engine, and remove the key from the
ignition.
6. If installed, move stabilizer/transport wheels so that
they are supported by header. Refer to
Stabilizer / Slow Speed Transport Wheels, page
7. Remove linkage cover (A) by removing bolt (B) and
rotating cover upward until inboard end can be lifted off.
NOTE:
Refer to the decal (A) inside each linkage cover.
214683
OPERATION
Adjusting
59.
Figure 3.55: Center-Link
Figure 3.56: Linkage Cover
Figure 3.57: Linkage Cover
74
A
B
C
A
B
A
Revision A