Installing Driven Drums And Driveline - MacDon R113 Operator's Manual

8. Slide driveline (A) downwards, tilt to the side, and pull
driveline up and out of drum.
NOTE:
For clarity, illustration shows cutaway view of drum and
tube shield.
9. Look down into the drum, and use a 305 mm (12 in.)
extension and 16 mm deep socket to remove the four
M12 bolts (A) and washers holding the drum disc
in place.
10. Remove drum disc assembly.

Installing Driven Drums and Driveline

DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage windrower lift cylinder safety props before going under machine for any reason.
CAUTION
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
NOTE:
Illustrations show left side drum and driveline—right side drum and driveline are similar.
214077
MAINTENANCE AND SERVICING
Figure 4.76: Vertical Driveline (Cutaway
View Shown)
Figure 4.77: Driven Drum (Top View, Arrow
Indicates Front of Machine)
141
A
A
Revision A