MacDon FlexDraper FD1 Series Operator's Manual page 126

4. Push/pull reel until bracket (B) lines up with the aft set
of holes in reel arm (C).
5. Reinstall four bolts (A) to secure bracket (B) to reel arm
at new position.
Reposition the right reel arm cylinder as follows:
NOTE:
Some reel components are not shown in illustrations for improved clarity.
1. Remove four bolts (A) securing cylinder bracket (B) to
the reel arm (C).
2. Push reel back until bracket (B) lines up with the aft set
of holes in the reel arm (C).
3. Reinstall the four bolts (A) to secure bracket to reel arm
at new position.
214683
OPERATION
Figure 3.109: Center Arm – Aft Position
Figure 3.110: Right Reel Arm Cylinder in
Forward Position
Figure 3.111: Right Reel Arm Cylinder in Aft
Position
102
B
C
A
B
C
A
B
C
A
Revision A