Configuring Reel Fore-Aft, Header Tilt, And Header Type (New Holland Cr Series) - MacDon FlexDraper FD1 Series Operator's Manual

Configuring Reel Fore-Aft, Header Tilt, and Header Type (New Holland CR Series)

This procedure applies only to 2016 New Holland CR models 6.90, 7.90, 8.90, and 9.90.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
1. Simultaneously press the UNLOAD (A) and
RESUME (B) buttons on the control handle.
2. On the HEAD 1 screen, change the CUTTING TYPE
from FLEX to PLATFORM as shown at location (A).
214683
OPERATION
Figure 3.507: New Holland Combine Controls
Figure 3.508: New Holland Combine Display
284
A
B
A
Revision A