MacDon FlexDraper FD1 Series Operator's Manual page 399

17. Loosen nut and bolt (A), and disengage hook (B) from
leg on both sides of float module.
18. Rotate hook (B) 90° for storage, and retighten bolt (A)
and nut.
19. Place a 150 mm (6 in.) block (A) under the header leg.
This will assist with disconnecting the center-link.
20. Disengage combine lift cylinder locks, start engine, and
lower header until the header leg rests on the block or
stabilizer wheels are the ground.
214683
HEADER ATTACHMENT/DETACHMENT
375
A
Figure 4.146: Float Module Underside
A
Figure 4.147: Float Module Underside
Figure 4.148: Header Leg on Block
B
B
A
Revision A