Feed Draper Speed - MacDon FlexDraper FD1 Series Operator's Manual

If the optional in-cab side draper speed control kit is
installed, rotate the knob (A) to the desired setting with the
header in either operating or shutdown mode. Set the knob
to 6 for normal crop delivery. Switch (B) activates the
header tilt or reel fore-aft controls. Refer to
Header Angle from Combine, page

Feed Draper Speed

The feed draper moves the cut crop from the side drapers into the float module feed auger.
The float module feed draper (A) is driven by a hydraulic
motor and a pump that is powered by the combine feeder
house drive through a gearbox on the float module.
The feed draper speed is determined by the combine feeder
house speed and cannot be independently adjusted.
214683
OPERATION
Adjusting
83.
93
Figure 3.96: In-Cab Side Draper Speed Control
A
Figure 3.97: FM100 Float Module
A
B
Revision A