MacDon FlexDraper FD1 Series Operator's Manual page 253

7. Press and hold REEL LOWER switch until reel is fully
lowered. Continue holding REEL LOWER switch until
prompted by the display.
8. Press and hold REEL RAISE switch until reel is fully
raised. Continue holding REEL RAISE switch until
prompted by the display.
9. When all steps have been completed, CALIBRATION
COMPLETE message is displayed on the screen. Exit
the CALIBRATION menu by pressing the ENTER
icon (A).
NOTE:
If an error code appears during calibration, the sensor is
out of voltage range and will require adjustment. Refer
to Checking Reel Height Sensor Voltages (John Deere
S and T Series), page
214683
225.
OPERATION
Figure 3.383: John Deere Combine Display
Figure 3.384: John Deere Combine Display
Figure 3.385: John Deere Combine Display
229
1023889
1023890
A
1023892
Revision A