MacDon FlexDraper FD1 Series Operator's Manual page 185

6. Locate the HEADER SUB TYPE field.
7. Select 2000 (A).
8. Select the HEAD 2 tab (A).
9. In the HEADER SENSORS field (B), select ENABLE.
10. In the HEADER PRESSURE FLOAT field (C),
select NO.
11. In the HEIGHT/TILT RESPONSE field (D), select FAST.
12. In the AUTO HEIGHT OVERRIDE field (E), select YES.
13. Press the down arrow (F) to go to the next page.
14. Locate the HHC HEIGHT SENSITIVITY field (A), and
set as follows:
•
If using a single-sensor system, set HHC HEIGHT
SENSITIVITY to 180.
•
If using a two-sensor system, set HHC HEIGHT
SENSITIVITY to 250.
NOTE:
If hunting occurs during operation, decrease this setting
by 20 points at a time until hunting no longer occurs.
15. Set the HHC TILT SENSITIVITY (B) to 150. Increase or
decrease as desired.
214683
OPERATION
Figure 3.235: Case IH Combine Display
Figure 3.236: Case IH Combine Display
Figure 3.237: Case IH Combine Display
161
A
B
C
D
E
A
F
A
B
Revision A