MacDon FlexDraper FD1 Series Operator's Manual page 265

10. Press button (A) on console to set engine to high idle.
11. Select START on calibration overview page.
12. Follow instructions that appear on combine display. As
you proceed through calibration process, display will
automatically update to show next step.
NOTE:
If an error code appears during calibration, sensor is out
of voltage range and will require adjustment. Refer to
Adjusting Voltage Limits: One-Sensor System, page
131.
13. When calibration is complete, select SAVE to confirm
calibration.
214683
OPERATION
Figure 3.413: John Deere S7 Console
Figure 3.414: John Deere S7 Display – Header
Calibration
Figure 3.415: John Deere S7 Display – Header
Calibration
241
A
1022828
Revision A