Installing Stripper Bars; Replacing Feed Deflectors On New Holland Cr Combines - MacDon FlexDraper FD1 Series Operator's Manual

5.13.2 Installing Stripper Bars

1. Detach the header from the combine. Refer to
Attachment/Detachment, page
2. Position the stripper bar (B) so the notch is at the corner
of the frame.
3. Secure the stripper bar (B) to the float module with four
bolts and nuts (A). Ensure the nuts are facing
the combine.
4. Repeat at the opposite side.

5.13.3 Replacing Feed Deflectors on New Holland CR Combines

1. Detach the header from the combine. Refer to
2. Remove the two bolts and nuts (B) securing the feed
deflector (A) to the float module frame, and remove the
feed deflector.
3. Position the replacement feed deflector (A), and secure
with bolts and nuts (B) (ensure the nuts are facing the
combine). Do NOT tighten nuts.
214683
MAINTENANCE AND SERVICING
4 Header
307.
4 Header Attachment/Detachment, page
483
Figure 5.179: Stripper Bar
B
Figure 5.180: Feed Deflector
A
B
307.
A
Revision A