MacDon FlexDraper FD1 Series Operator's Manual page 519

1. Start the engine, raise the header, and raise the reel.
2. Shut down the combine, and remove the key from the
ignition.
3. Engage the reel safety props, and engage the header
safety props.
4. Loosen the draper by turning adjuster bolt (A)
counterclockwise.
5. Remove the screws (A), tube connectors (B), and nuts
from the draper joint to uncouple the draper.
6. Pull the draper off the idler roller.
7. Remove the bolts (A) and washer at both ends of the
idler roller.
NOTE:
Remove the bolt at the back of the deck first. This will
give you extra room to access the bolt under the
cutterbar.
8. Spread the roller arms (B) and (C), and remove the idler
roller.
214683
MAINTENANCE AND SERVICING
Figure 5.202: Tensioner
Figure 5.203: Draper Connector
Figure 5.204: Idler Roller
495
A
A
B
A
B
A
C
Revision A