Replacing Reel Height Sensor - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

15. Recheck voltage range Y and ensure it is still within the

range specified. Adjust if required.

Replacing Reel Height Sensor

To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key

before making adjustments to machine.

1. Start engine and lower reel fully.

2. Stop engine and remove key.

3. Disconnect sensor from harness.

4. Remove two hex head bolts (A) from sensor arm (B).

Retain hardware for reinstallation.

5. Remove two nyloc nuts and bolts (A) from reel height

sensor and remove sensor (B).

6. Install new sensor (B) in sensor bracket and attach

using retained bolts (A) and nyloc nuts. Torque bolts (A)

to 2–3 Nm (17–27 lbf·in.).

Figure 3.102: Reel Height Sensor – Right

Figure 3.103: Reel Height Sensor – Right