New Holland Combines (Cr Series-Model Year 2015 And Later); Checking Voltage Range From The Combine Cab (New Holland Cr Series) - MacDon FlexDraper FD1 Series Operator's Manual

of 2 seconds to store the new height position. A beep
will confirm setting.
NOTE:
Fully pressing AUTOMATIC HEADER HEIGHT
CONTROL button (E), will disengage float mode.
NOTE:
It is not necessary to press rocker switch (D) again after
changing header height set point.
3.8.16 New Holland Combines (CR Series—Model Year 2015 and Later)
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
page 261.

Checking Voltage Range from the Combine Cab (New Holland CR Series)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
page 261.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Position the header 150 mm (6 in.) above the ground, and unlock the float.
214683
OPERATION
3.8.15 New Holland Combines (CR/CX Series—Pre-2015 Model Year),
3.8.15 New Holland Combines (CR/CX Series—Pre-2015 Model Year),
271
Revision A