MacDon FlexDraper FD1 Series Operator's Manual page 348

2. Remove bolts (A) and access cover (B) from the right
side of the auger. Retain for reassembly.
3. Remove hardware (C) and bolt-on flighting (D) from
the auger.
4. Remove the flighting slot plug (E) located close to the
end of the flighting (D).
5. Converting from Medium configuration: Repeat
above steps for the other bolt-on flighting on the
same side.
6. Converting from Wide configuration: Remove
bolts (A), access cover (B), and two flighting slot
plugs (C) from the right side of the auger.
7. Repeat Steps 2, page 324
of the auger.
8. Position two bolt-on flightings (A) on the right side, as
shown. Temporarily secure flightings with two carriage
head bolts and nuts at each location (B).
214683
HEADER ATTACHMENT/DETACHMENT
to 6, page 324 at the left side
E
B
Figure 4.32: Wide Configuration (Right Side)
C
C
Figure 4.33: Wide Configuration (Right Side)
Figure 4.34: Right Side of Auger
324
D
A
A
B
A
B
C
Revision A
C