Setting Up Auto Header Height Control (New Holland Cr Series) - MacDon FlexDraper FD1 Series Operator's Manual

9. Select GRAPH (A). The exact voltage (B) is displayed
at the top of the screen.
10. Raise and lower the header to see the full range of
voltage readings.
11. If the sensor voltage is not within the low and high
limits, or if the range between the low and high limits is
insufficient, adjust the voltage limits. Refer to
Voltage Limits: One-Sensor System, page

Setting up Auto Header Height Control (New Holland CR Series)

For best performance of the auto header height control (AHHC), perform these procedures with the center-link set
to D. When setup and calibration are complete, adjust the center-link back to desired header angle.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
page 261.
1. Ensure center-link is set to D.
2. Select TOOLBOX (A) on the main screen. The
TOOLBOX screen displays.
214683
OPERATION
Adjusting
131.
3.8.15 New Holland Combines (CR/CX Series—Pre-2015 Model Year),
274
Figure 3.481: New Holland Combine Display
Figure 3.482: New Holland Combine Display
B
A
A
Revision A