Calibrating The Auto Header Height Control (John Deere 60 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Calibrating the Auto Header Height Control (John Deere 60 Series)

For best performance of the auto header height control (AHHC), perform these procedures with the center-link set

to D. When setup and calibration are complete, adjust the center-link back to desired header angle. For

instructions, refer to

3.7.5 Header Angle, page

Changes may have been made to the combine controls or display since this document was published. Refer to the

combine operator's manual for updates.

Check to be sure all bystanders have cleared the area.

If header float is set too light, it can prevent calibration of AHHC. You may need to set the float heavier for

calibration procedure so header doesn't separate from the float module.

1. Ensure center-link is set to D.

2. Rest header on down stops, and unlock float.

3. Put wings in locked position.

4. Start the combine.

5. Press the DIAGNOSTIC button (A) on the monitor. DIA

appears on the monitor.

6. Press the CAL button (B). DIA-CAL appears on the

Figure 3.316: John Deere Combine Display