Detaching Header From Case Ih Combine - MacDon FlexDraper FD1 Series Operator's Manual

4.3.2 Detaching Header from Case IH Combine

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Choose a level area and position the header slightly
above the ground.
2. Stop the engine and remove the key from the ignition.
IMPORTANT:
If slow speed transport wheels are installed, the header
may be detached in either transport or field mode. If
detaching with the wheels in field mode, set the wheels
to the storage or uppermost working position, otherwise
the header may tilt forward, making reattachment
difficult. Refer to Adjusting Stabilizer / Slow Speed
Transport Wheels, page
IMPORTANT:
If stabilizer wheels are installed, set the wheels to the
storage or uppermost working position, otherwise the
header may tilt forward, making reattachment difficult.
Refer to Adjusting Stabilizer Wheels, page
3. Engage the float locks by pulling each float lock
handle (A) away from the float module and setting it in
the locked position (B).
4. Push back the collar (A) on the end of the driveline and
pull the driveline out of the combine output shaft (B)
until the collar disengages.
214683
HEADER ATTACHMENT/DETACHMENT
59.
60.
Figure 4.60: Float Lock Handle (Right Side
Shown in Detail, Left Side Opposite)
Figure 4.61: Driveline
337
A
B
B
A
Revision A