MacDon FlexDraper FD1 Series Operator's Manual page 405

20. Remove screw (A) and remove nut and bolt (B) from
both sides of the opening to allow the attachment of the
float module deck.
21. Rotate the latch (C) forward and down to engage the
transition pan tube.
22. Use a 24 mm (15/16 in.) wrench on hex bolt (C) to
rotate latch downwards and slightly raise the feed deck.
Install nut and bolt (B) to lock the latch position.
23. Install screw (A).
24. Repeat for the opposite side of the feed draper deck.
25. Install fillers (B) on the transition pan support angle (C)
using two bolts (A).
214683
HEADER ATTACHMENT/DETACHMENT
381
A
Figure 4.162: Float Module Latch
A
Figure 4.163: Float Module Latch
B
C
A
Figure 4.164: Fillers
B
B
C
1017149
B
C
1017134
Revision A