Adjusting The Threshold For The Drop Rate Valve (John Deere 60 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Adjusting the Threshold for the Drop Rate Valve (John Deere 60 Series)

This procedure explains how to adjust the point at which the restrictor valve opens allowing full flow to the lift

Changes may have been made to the combine controls or display since this document was published. Refer to the

combine operator's manual for updates.

The numbers depicted on the displays in these illustrations are for reference purposes only; they are not intended

to represent the specific settings for your equipment.

1. Press the DIAGNOSTIC button (A) on the monitor. DIA

appears on the monitor.

2. Press the UP button (B) until EO1 appears on the

monitor and press ENTER (C). This is the header

3. Press the UP (B) or DOWN button until 114 is displayed

on the top portion of the monitor. This is the setting that

adjusts when the fast drop rate starts with respect to the

The default setting is 100. Ideal operating range is

typically between 60 and 85.

4. Press ENTER (C) to select 114 as the fast drop rate

(this will allow you to change the first digit of the number

5. Press UP (B) or DOWN (E) until the desired number is

displayed, then press the CAL button (D). This will bring

you to the second digit. Repeat this procedure until the

desired setting is achieved.

6. Press ENTER (C) to save changes.

Figure 3.323: John Deere Combine Display