MacDon FlexDraper FD1 Series Operator's Manual page 366

6. Start the engine and lower the header.
7. Stop the engine and remove the key from the ignition.
NOTE:
The FM100 Float Module is equipped with a multicoupler that connects to the combine. If your combine is
equipped with individual connectors, a multicoupler kit (single-point connector) must be installed. Refer to
Table 4.1, page 342
Table 4.1 Multicoupler Kits
Challenger
Gleaner R/S Series
Massey Ferguson
8. Disengage the float locks by pulling each float lock
handle (A) away from the float module and setting it in
the unlocked position (B).
214683
HEADER ATTACHMENT/DETACHMENT
for a list of kits and installation instructions that are available through your combine Dealer.
Combine
B
Figure 4.72: Float Lock Handle (Right Side
Shown in Detail, Left Side Opposite)
342
Kit Number
71530662
71414706
71411594
A
Revision A