Reel Drive Motor; Removing Reel Drive Motor; Installing Reel Drive Motor - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

5.16.5 Reel Drive Motor

The reel drive motor does not require regular maintenance or servicing. If problems occur with the motor, remove it

and have it serviced by your MacDon Dealer.

To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key

from ignition before leaving operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

2. Loosen the drive chain. Refer to

3. Remove the drive sprocket. Refer to

4. Mark hydraulic lines (A) and their locations in the

motor (B) to ensure correct reinstallation.

5. Disconnect hydraulic lines (A) at motor (B). Cap or plug

open ports and lines.

6. Remove four nuts and bolts (C), and remove the

motor (B). Retrieve the spacer (if installed) from

between motor (B) and the motor mount.

7. If the motor is being replaced, remove the hydraulic

fittings from the old motor and install them in the new

motor using the same orientations. Refer to

Reference, page 577

1. Slide motor mount (A) up or down so the motor

mounting holes (B) are accessible through the openings

in the chain case.

MAINTENANCE AND SERVICING

Loosening Reel Drive Chain, page

Removing Reel Drive Sprocket, page

for torque specifications.

Figure 5.292: Reel Motor and Hoses

Figure 5.293: Reel Drive Motor Mounting Holes