MacDon FlexDraper FD1 Series Operator's Manual page 245

3. Select AUTO HEIGHT SENSING (A), RETURN TO
CUT (B), and REEL POSITION (C) icons.
NOTE:
If REEL POSITION icon (C) cannot be selected (no
check mark), the reel height sensor requires calibration.
Refer to Calibrating Reel Height Sensor (John Deere S
and T Series), page
4. Engage the header.
5. Move header to desired position and use knob (A) to
fine tune position.
6. Move reel to desired position.
7. Press and hold preset switch 2 (B) until 1 reel height
icon flashes on monitor.
8. Repeat previous three steps for preset switch 3 (C).
9. Select an appropriate ground pressure setting. Use
preset button 2 (B) on the control handle for a low
ground pressure setting in muddy or soft soil conditions,
and preset 3 (C) for a high ground pressure setting in
firm soil conditions and a higher ground speed.
NOTE:
Preset button 1 (A) is reserved for header lift on the
headland and is not used for cutting on ground.
214683
227.
OPERATION
Figure 3.362: Combine Display
Figure 3.363: Combine Control Console
B
C
Figure 3.364: Control Handle Buttons
221
A B
C
A
A
Revision A