MacDon FlexDraper FD1 Series Operator's Manual page 389

11. Remove the hydraulic quick coupler (A) from the
storage plate on the combine, and clean the mating
surface of the coupler.
12. Position the coupler (A) onto the float module
receptacle, and push the handle (B) to engage the pins
into the receptacle.
13. Push the handle (B) to closed position until the lock
button (C) snaps out.
14. Remove the cover on the float module electrical
receptacle.
15. Remove the connector (D) from the combine.
16. Align the lugs on the connector (D) with the slots in the
float module receptacle, and push the connector onto
the receptacle. Turn the collar on the connector to lock
it in place.
17. Detach safety chain (C) from support bracket (B).
18. Pull collar (D) back to release driveline (A) from support
bracket. Remove the driveline from support bracket.
214683
HEADER ATTACHMENT/DETACHMENT
365
A
Figure 4.124: Combine Coupler
D
A
C
B
Figure 4.125: Connections
A
C
Figure 4.126: Driveline in Storage Position
D
B
1024063
Revision A