Attaching Tow-Bar - MacDon FlexDraper FD1 Series Operator's Manual

Attaching Tow-Bar

The tow-bar consists of two sections which make storage and handling easier.
1. Unhook the rubber strap (D) from the cradle (A) on the
right side of the header.
2. Remove the clevis pin (C) and detach the tube end from
the support (B).
3. Replace the clevis pin (C).
4. Lift the inner half of the tow-bar off the header and place
it near the left side of the header.
5. Unhook the rubber strap (D) from the cradle (A) on the
left side of the header.
6. Remove the hitch pin (C) from the support (B), and
remove the tow-bar.
7. Install the rubber strap (D) on the cradle (A).
214683
OPERATION
Figure 3.538: Tow-Bar Removal – Right Side
Figure 3.539: Tow-Bar Removal – Left Side
303
D
A
B
B
A
C
C
1004705
D
Revision A