Chapter 4: Header Attachment/Detachment; Float Module Feed Auger Configurations - MacDon FlexDraper FD1 Series Operator's Manual

4 Header Attachment/Detachment
This chapter includes instructions for setting up, attaching, and detaching the header.
Case IH 7010, 8010, 7120, 8120, 9120, 5130, 6130,
7130, 7230, 8230, 9230
Gleaner R and S Series, Challenger 660, 670, 680B,
540C, 560C, Massey Ferguson 9690, 9790, 9895,
9520, 9540, 9560
John Deere 60, 70, S, and T Series
CLAAS 500, 700 (R Series)
New Holland CR, CX
NOTE:
Ensure the applicable functions (e.g., Automatic Header Height Control [AHHC], draper header option, hydraulic
center-link option, hydraulic reel drive) are enabled on the combine and the combine computer. Failure to do so
may result in improper header operation.

4.1 Float Module Feed Auger Configurations

The FM100 feed auger can be configured to suit various crop conditions; there are four configurations available.
Check the conversion instructions to determine if additional auger flighting kits are required.
Narrow configuration is a standard configuration for the
following combines:
•
Gleaner (R6/75, R6/76, S6/77, S6/7/88, S96/7/8)
•
New Holland CR (920/940/960, 9020/40/60/65,
6090/7090, 8060/8070/8080)
214683
Combine
4.3 Case IH Combines, page 332
4.4 AGCO (Challenger, Gleaner, and Massey
Ferguson) Combines, page 340
4.5 John Deere Combines, page 348
4.6 CLAAS Combines, page 355
4.7 New Holland Combines, page 363
A
B
Figure 4.1: Narrow Configuration (Rear View)
A - 514 mm (20-1/4 in.)
NOTE:
Dimensions are the same for both ends of the
auger. They should be within 15 mm (9/16 in.) of
the numbers given.
307
Refer to
B - 356 mm (14 in.)
Revision A