MacDon FlexDraper FD1 Series Operator's Manual page 336

8. Install two bolt-on flightings (A) on the left side of the
auger as shown, and secure each flighting with six
carriage head bolts and nuts retained from Step
311 at location (B).
IMPORTANT:
Flighting bolt heads must be installed on inside of auger
to prevent damage to internal components.
NOTE:
Flightings are NOT included in this kit. Order flighting
kits MD #287031 separately.
9. Torque all nuts and bolts to 47 Nm (35 lbf·ft) to eliminate
deflection on flighting, then torque them to 58–64 Nm
(43–47 lbf·ft).
10. Use the access hole (A) to position the flighting slot
plug (B) from inside the feed auger (as shown) and
secure with a 20 mm long M6 hex head bolt (C) and tee
nut. Use flighting and hardware retained from Step
page 311. Repeat for the remaining locations used to
mount the flighting in Step
page 311.
11. Install additional auger fingers. A total of 22 auger
fingers is recommended for this configuration. Refer to
Installing Feed Auger Fingers, page
214683
HEADER ATTACHMENT/DETACHMENT
3, page
3, page 311 and Step 4,
431.
Figure 4.9: Medium Configuration (Left Side)
5,
C
Figure 4.10: Medium Configuration Flighting
Plug (Right Side)
312
A
B
A
B
A
Revision A