MacDon FlexDraper FD1 Series Operator's Manual page 130

Reposition right reel arm cylinder as follows:
NOTE:
Some reel components are not shown in illustrations for improved clarity.
NOTE:
Reels on European-configured headers are at their most forward setting when cylinders are set in position 2 on the
fore/aft arm brackets. Reels on these headers are in their most aft position when cylinders are set in position 1 on
the fore-aft arm brackets.
1. Remove ring (A), pin (B), and washers (D) securing the
reel arm cylinder (C) to the interior of the right fore-aft
arm bracket. Retain washers, ring, and pin.
2. Push the reel back until the end of the cylinder (A) lines
up with the aft setting holes (B) in the support
bracket (C). Position washers (D) on both sides of the
cylinder end (A) inside the support bracket (C).
214683
OPERATION
Figure 3.117: Right Reel Arm Cylinder in
Forward Position
Figure 3.118: Right Reel Arm Cylinder
106
C
B
B
C
D
A
A
D
Revision A