Leveling The Header - MacDon FlexDraper FD1 Series Operator's Manual

3.9 Leveling the Header

The float module is factory-set to provide the proper level for the header and should not normally require
adjustment.
If the header is NOT level, perform the following checks prior to adjusting the leveling linkages:
•
Check the combine tire pressures.
•
Check that the combine feeder house is level. Refer to your combine operator's manual for instructions.
•
Check that the top of the float module is level and parallel with the feeder house.
NOTE:
The float springs are NOT used to level the header.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Park the combine on level ground.
2. Set the header approximately 150 mm (6 in.) off the ground, and check that the float linkage is against the
down stops. Note the high and low end of the header.
3. Shut down the engine and remove the key.
4. Set wing float lock (A) to engaged. Refer to
Rigid Mode, page 71.
5. Check, and if necessary adjust the float. Refer to
Checking and Adjusting Header Float, page
214683
OPERATION
Operating in
64.
Figure 3.511: Wing Lock
286
A
Revision A