Setting Up Auto Header Height Control (New Holland Cr/Cx Series) - MacDon FlexDraper FD1 Series Operator's Manual

9. Select LEFT HEADER HEIGHT SEN (A), and then
select GRAPH button (B). The exact voltage is
displayed at the top of the screen.
10. Raise and lower the header to see the full range of
voltage readings.
11. If the sensor voltage is not within the low and high
limits, or if the range between the low and high limits is
insufficient, adjust the voltage limits. Refer to
Voltage Limits: One-Sensor System, page

Setting up Auto Header Height Control (New Holland CR/CX Series)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
Series—Model Year 2015 and Later), page
1. Select HEADER LATERAL FLOAT on the combine
display, and press ENTER.
2. Use the up and down navigation keys to move between
options, and select INSTALLED.
214683
OPERATION
Adjusting
131.
Figure 3.464: New Holland Combine Display
271.
Figure 3.465: New Holland Combine Display
264
A
3.8.16 New Holland Combines (CR
B
1003581
Revision A