MacDon FlexDraper FD1 Series Operator's Manual page 10

Added topics.
Revised caution statement about reduced header
stability when cornering.
•
Removed mentions of discontinued flighting
bundles B6215 and B6216.
•
Updated feed auger illustrations.
Updated feed auger illustrations.
•
Added changing oil in header drive gearbox (first 50
hours only).
•
Added lubricating center draper roller bearings
(every 50 hours).
•
Added checking draper roller bearings for heat
(every 200 hours)
Added checking and adjusting finger timing
instructions.
Revised topic—No adjustment is required if spring
retainers are within +6 to –3 of flush and feed draper is
tracking properly.
Updated torque value for center reel arm brace bolts.
Updated illustration to show new bolt orientation.
Updated reel speed sensor illustrations.
Updated load range D tire pressure to 75 psi.
Added topics.
214683
•
Calibrating Reel Height Sensor (CLAAS 600 and
700 Series), page 258
•
Adjusting Auto Reel Height (CLAAS 600 and 700
Series), page 260
Towing the Header, page 291
4.1 Float Module Feed Auger Configurations, page 307
•
5.7.2 Checking Auger Drive Chain Tension, page
421
•
5.7.3 Adjusting Auger Drive Chain Tension, page
423
•
5.7.4 Removing Auger Drive Chain, page 424
•
5.7.5 Installing Auger Drive Chain, page 426
5.3.1 Maintenance Schedule/Record, page 385
•
Checking Auger Finger Timing, page 434
•
Adjusting Auger Finger Timing, page 435
5.10.2 Adjusting Feed Draper Tension, page 468
5.15.3 Centering Double Reel, page 507
•
Replacing AGCO (Challenger, Gleaner, and
Massey Ferguson) Sensor, page 538
•
Replacing John Deere Reel Speed Sensor, page
540
5.17.3 Checking Tire Pressure, page 544
•
6.4.6 Center Skid Shoes Kit, page 554
•
6.5.9 European Combine Upper Cross Auger
(UCA), page 559
viii
Revision A