MacDon FlexDraper FD1 Series Operator's Manual page 303

3. Select HEADER (A) from the list of calibration options.
4. Follow the calibration steps in the order in which they
appear on the screen. As you proceed through the
calibration process, the display will automatically
update to show the next step.
NOTE:
Pressing the ESC key during any of the steps or letting
the system sit idle for more than 3 minutes will cause
the calibration procedure to stop.
NOTE:
Refer to your combine operator's manual for an
explanation of any error codes.
5. When all steps have been completed, CALIBRATION
COMPLETED message is displayed on the screen.
NOTE:
If float was set heavier to complete AHHC calibration
procedure, adjust to recommended operating float after
the calibration is complete.
214683
OPERATION
Figure 3.493: New Holland Combine Display
Figure 3.494: New Holland Combine Display
Figure 3.495: New Holland Combine Display
279
A
Revision A