MacDon FlexDraper FD1 Series Operator's Manual page 218

5. The hazard message warning screen for HEADER
CALIBRATION appears. Make sure that all conditions
are met.
6. Touch the green check mark at the bottom of the screen
to start the CALIBRATION WIZARD.
A progress bar is provided and the calibration can be
stopped at any time by touching the red X. The header
moves automatically and erratically during this process.
7. When the calibration is complete, a message displays,
and summary information (A) is shown. Green check
marks confirm the functions have been calibrated (B).
Touch the bottom green check mark (C) to save.
214683
OPERATION
Figure 3.302: Header Calibration Warning
Figure 3.303: Calibration In Progress
A
B
Figure 3.304: Completed Calibration Page
194
C
Revision A