Replacing Float Indicator Cable - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Replacing Float Indicator Cable

If the float indicator cable is damaged, replace it following these instructions. You will need to order one float

indicator cable (MD #187658) from your MacDon Dealer.

Some parts have been removed for illustration purposes.

1. On the left front side of the float module, remove nut,

washer, and bolt (A) securing the cable eye on the end

of float indicator cable (B) to the float lever. Retain

hardware for reinstallation.

2. Loosen jam nuts (C) on float indicator cable (B), and

then disconnect the cable from cable stop support (D).

3. Repeat steps on right front side of the float module.

4. Loosen jam nuts (A) securing float indicator cable (B) to

both sides of the float indicator bottom support, and

then disconnect the cable from the support.

5. Float indicator cable (B) is routed around three

pulleys (C) in the float indicator box. Remove the cable

and discard.

Pulleys are hidden by other parts in the illustration.

Their approximate location is identified.

Figure 3.174: Left Front Side of Float Adapter –

Right Side is Opposite

Figure 3.175: Float Indicator Box