Removing Endshields - MacDon FlexDraper FD1 Series Operator's Manual

2. Loosen the three bolts (A) on latch assembly (B).
3. Adjust latch assembly (B) to achieve the desired gap
between the front end of the shield and the header
frame. Refer to Table
recommended endshield gap at various temperatures.
4. Tighten the three bolts (A) on the latch assembly.
5. Tighten the four bolts (A) on support tube bracket (B).
6. Close endshield.

Removing Endshields

1. Fully open the endshield. For instructions, refer to
Opening Endshields, page
2. Engage lock (A) to prevent endshield movement.
3. Remove self-tapping screw (B).
4. Slide endshield upwards and remove from hinge
arm (C).
5. Place endshield away from work area.
214683
3.1, page 35 for the
33.
OPERATION
Figure 3.14: Left Endshield Latch Assembly
Figure 3.15: Left Endshield Support Tube
A
Figure 3.16: Left Endshield
36
B
A
A
A
B
A
A
B
C
C
Revision A