MacDon FlexDraper FD1 Series Operator's Manual page 321

6. Pull the pin (A) on brace (B) on the right wheel in front
of the cutterbar. Disengage the brace from the
cutterbar, and lower the brace against the axle (C).
7. Remove pin (D), lower support (E) onto axle, and
reinsert pin into support.
8. Swing the axle (C) clockwise towards the rear of the
header.
9. Pull pin (A) on right axle, swivel the wheel
counterclockwise to position shown, and lock with
pin (A).
10. Remove the hairpin (B) from the latch (C).
11. Lift the wheel, lift latch (C), and engage lug (D) onto the
left axle. Ensure the latch closes.
12. Secure the latch with hairpin (B), ensuring the open end
of the pin faces the rear of the combine.
NOTE:
The hairpin can become dislodged by crop if installed
with the open end facing the cutterbar.
IMPORTANT:
Check that wheels are locked and that handle is in
locked position.
214683
OPERATION
C
Figure 3.525: Rear Wheel – Right Side
Figure 3.526: Rear Wheels
297
A
E
D
A
D
B
B
C
Revision A