Safety Signs; Installing Safety Decals - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

1.6 Safety Signs

Keep safety signs clean and legible at all times.

Replace safety signs that are missing or illegible.

If original part on which a safety sign was installed is

replaced, be sure repair part also bears current

safety sign.

Replacement safety signs are available from your

MacDon Dealer Parts Department.

1. Clean and dry installation area.

2. Decide on exact location before you remove decal backing paper.

3. Remove smaller portion of split backing paper.

4. Place decal in position and slowly peel back remaining paper, smoothing decal as it is applied.

5. Prick small air pockets with a pin and smooth out.

Figure 1.14: Operator's Manual Decal