MacDon FlexDraper FD1 Series Operator's Manual page 527

Table 5.4 Finger to Guard/Cutterbar Clearance
(X) 3 mm (+/- 1/8 in. ) at Reel Ends
Header Width
9.1 m (30 ft.)
10.7 m (35 ft.)
12.2 m (40 ft.)
13.7 m (45 ft.)
1. Park the header on level ground.
2. Move spring handles (A) down to (UNLOCK) position.
3. Raise header and place two 150 mm (6 in.) blocks (A)
under the cutterbar, just inboard of the wing flex points.
4. Lower header fully, allowing it to flex into a full
frown mode.
214683
MAINTENANCE AND SERVICING
and Flex Locations
20 mm
(3/4 in.)
X
Figure 5.219: Finger Clearance
Figure 5.220: Wing Lock in UNLOCK Position
Figure 5.221: FlexDraper
503
A
A
® ®
Block Locations
Revision A