Installing Tall Crop Feed Plates: Under Driven Deflector; Installing Tall Crop Feed Plates: Under Driveline Deflector - MacDon R85 Operator's Manual

Installing Tall Crop Feed Plates: Under Driven Deflector
1. Remove driven deflector.
Driven Deflector, page
2. Locate tall crop feed plates from storage. Refer to
6.10.1 Locating Tall Crop Feed Plates for Installation,
page 82.
3. Locate feed plate (A) on the disc, ensuring that
hole in feed plate registers on disc. Position plate
approximately as shown and align holes.
IMPORTANT:
Depending on disc (B) rotation, feed plate (A) should be
located so that when holes are aligned, the leading edge
of the feed plate is further from the accelerator (B) than
the trailing edge.
4. Install the deflector.
Deflector, page 142.
Installing Tall Crop Feed Plates: Under Driveline Deflector
1. Locate feed plates. Refer to
Feed Plates for Installation, page
2. Lower the header fully.
3. Shut down the engine and remove the key.
4. Open cutterbar door(s). Refer to
page 33.
5. Install feed plate (A) on the disc.
169457
OPERATING THE HEADER
Refer to
Removing the
141.
Refer to
Installing the Driven
6.10.1 Locating Tall Crop
82.
5.5 Cutterbar Doors,
Figure 6.24: RH End
Figure 6.25: RH End Top View
Figure 6.26: LH End Shown
83
Revision G