MacDon FlexDraper FD1 Series Operator's Manual page 403

7. Adjust the length of the center-link (A) using the header
angle hydraulics to approximately align the center-link
eye (B) with the hole in the header bracket.
8. Shut down the engine and remove the key from the
ignition.
9. Connect the center-link as follows:
a. Pull pin (B) part way out of the bracket (C), and
remove the prop from under the center-link (A).
b. Install the pin (B) through the center-link
bracket (C), and secure with lynch pin.
CAUTION
Always connect center-link before fully raising header.
CAUTION
Be sure all bystanders are clear of machine before starting engine or engaging any header drives.
10. Start the engine and slowly raise the float module while making sure the float module legs engage the
header legs.
11. Raise the header to its full height, stop the engine, and remove the key from the ignition.
12. Engage the safety props on the combine.
214683
HEADER ATTACHMENT/DETACHMENT
379
B
A
Figure 4.157: Center-Link
B
A
C
Figure 4.158: Center-Link
Revision A