Converting From Transport To Field Position; Removing Tow-Bar - MacDon FlexDraper FD1 Series Operator's Manual

3.12.3 Converting from Transport to Field Position

Removing Tow-Bar

1. Block the tires to prevent the header from rolling, and
unhook the header from the towing vehicle.
2. Disconnect the electrical connector (A) on the tow-bar.
3. Remove pin (B) from the tow-bar, and disassemble the
outer section (C) from the inner section (D).
4. Disconnect the electrical connector (A) at the
front wheel.
5. Remove clevis pin (A) and set aside for reinstallation.
6. Push latch (B) and lift the tow-bar (C) from the hook.
Release latch.
7. Install clevis pin (A).
214683
OPERATION
D
Figure 3.514: Tow-Bar Assembly
Figure 3.515: Wiring Connector
B
C
Figure 3.516: Tow-Bar Latch
292
A
B
C
A
A
Revision A