Replacing Drive Chain On Double Reel - MacDon FlexDraper FD1 Series Operator's Manual

2. Attach motor (A) (and spacer if previously removed) to
motor mount (B) with four 1/2 x 1-3/4 in. countersunk
bolts and nuts (C).
3. Torque nuts (C) to 73 Nm (54 lbf∙ft).
4. If installing a new motor, install the hydraulic fittings (not
shown) from the original motor and torque to
110–120 Nm (81–89 lbf·ft).
5. Remove the caps or plugs from the ports and lines and
connect hydraulic lines (A) to hydraulic fittings (B) on
motor (C).
NOTE:
Ensure hydraulic lines (A) are installed in their original
locations.
6. Install the drive sprocket. Refer to
Sprocket, page 531.
7. Tighten the drive chain. Refer to
Chain, page 528.

5.16.6 Replacing Drive Chain on Double Reel

WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
1. Shut down the engine, and remove the key from the ignition.
2. Remove drive reel drive cover. Refer to
3. Loosen the drive chain. Refer to
214683
MAINTENANCE AND SERVICING
Installing Reel Drive
Tightening Reel Drive
Removing Reel Drive Cover, page
Loosening Reel Drive Chain, page
535
C
B
Figure 5.294: Reel Drive Motor
A
Figure 5.295: Reel Motor and Hoses
526.
528.
A
C
B
Revision A