MacDon FlexDraper FD1 Series Operator's Manual page 537

9. Remove the reel endshields and endshield support (C)
from the tail end of the reel at the applicable tine tube
location.
NOTE:
There are no endshields on the center disc.
10. Remove the bolts (A) securing the tine tube arms (B) to
the tail and center discs.
11. Release the bushing clamps or disconnect the support
channels from the tine tube support (if installed)
depending on which tine tube is being moved. Three
tine tubes (A) require channel disconnection and two
tine tubes (B) require only bushing clamp removal.
12. Remove bolt (A) from the cam linkage so the tine
tube (B) is free to rotate.
214683
MAINTENANCE AND SERVICING
Figure 5.240: Tail End
Figure 5.241: Tine Tube Supports
Figure 5.242: Cam End
513
B
A
B
A
A
C
B
Revision A