MacDon FlexDraper FD1 Series Operator's Manual page 357

5. On the left side of the feeder house, lift lever (A) on the
float module and push handle (B) on the combine to
engage locks (C) on both sides of the feeder house.
6. Push down on the lever (A) so the slot in the lever
engages the handle and locks the handle in place.
7. If lock (C) does not fully engage the pin on the float
module, loosen bolts (D) and adjust lock.
Retighten bolts.
8. Open the cover on the receptacle (A) located on the left
side of the float module.
9. Press the lock button (B) and pull the handle (C) to the
fully-open position.
10. Clean the receptacle mating surfaces.
11. Remove the hydraulic quick coupler (A) from the
combine, and clean the mating surfaces.
214683
HEADER ATTACHMENT/DETACHMENT
333
C
Figure 4.50: Combine and Float Module
B
C
Figure 4.51: Float Module Receptacle
Figure 4.52: Combine Connectors
B
A
D
A
A
Revision A